[Offer] CCNA v4 - E4 - Module 7 (100%) -> latest

[4cisco]

Please Login to view content

Please Login to view content

1. Refer to the exhibit. IPv6 address 2006:1::1/64 eui-64 has been configured on the router FastEthernet0/0 interface. Which statement accurately describes the EUI-64 identifier configuration?

Please Login to view content

2. Refer to the exhibit. Which address or addresses represent the inside global address?

Please Login to view content

3. Your organization is issued the IPv6 prefix of 2001:0000:130F::/48 by your service provider. With this prefix, how many bits are available for your organization to create subnetworks?

Please Login to view content

4. What are two benefits of NAT? (Choose two.)

Please Login to view content

Please Login to view content

.

5. What is true regarding the differences between NAT and PAT?

Please Login to view content

Please Login to view content

Please Login to view content

Please Login to view content

6. A network administrator wants to connect two IPv6 islands. The easiest way is through a public network that uses only IPv4 equipment. What simple solution solves the problem?

Please Login to view content

7. Refer to the exhibit. Which two addresses could be assigned to traffic leaving S0 as a result of the statement ip nat pool Tampa 179.9.8.96 179.9.8.111 netmask 255.255.255.240? (Choose two.)

Please Login to view content

Please Login to view content

8. Refer to the exhibit. The FTP server has an RFC 1918 private address. Users on the Internet need to connect to the FTP server on the Fa0/0 LAN of R1. Which three configurations must be completed on R1? (Choose three.)

Please Login to view content

Please Login to view content

Please Login to view content

9. After activating IPv6 routing on a Cisco router and programming IPv6 addresses on multiple interfaces, what is the remaining step to activate RIPng?

Please Login to view content

10. Refer to the exhibit. How many IPv6 broadcast domains exist in this topology?

Please Login to view content

11. Refer to the exhibit. Traffic exiting R1 is failing translation. What part of the configuration is most likely incorrect?

Please Login to view content

12. Refer to the exhibit. According to the output, how many addresses have been successfully assigned by this DHCP server?

Please Login to view content

13. Refer to the exhibit. What is the purpose of the command marked with an arrow shown in the partial configuration output of a Cisco broadband router?

Please Login to view content

14. A technician has been told by a supervisor to always clear any dynamic translations before attempting to troubleshoot a failed NAT connection. Why has the supervisor issued these instructions?

Please Login to view content

15. Refer to the exhibit. Which two statements about the configuration are true? (Choose two.)

Please Login to view content

Please Login to view content

16. Refer to the exhibit. R1 is performing NAT for the 10.1.1.0/24 network, and R2 is performing NAT for the 192.168.1.2/24 network. What would be valid destination IP address for HostA to put in its IP header when communicating with the web server?

Please Login to view content

17. What type of NAT should a network administrator use to ensure that a web server on the inside network is always available to the outside network?

Please Login to view content

18. How many bits of an IPv6 address are used to identify the interface ID?

Please Login to view content

19. Refer to the exhibit. A technician used SDM to enter the NAT configuration for a Cisco router. Which statement correctly describes the result of the configuration?

Please Login to view content

20. Refer to the exhibit. A network technician determines DHCP clients are not working properly. The clients are receiving IP configuration information from a DHCP server configured on the router but cannot access the Internet. From the output in the graphic, what is the most likely problem?

Please Login to view content

21. Refer to the exhibit. On the basis of the configuration shown, how should the pool of the excluded addresses be assigned to key hosts on the network, such as router interfaces, printers, and servers?

Please Login to view content