CCna 3: CNS Practice Skill Switching- Solutions?

[hotwine]

there is someone that have solutions of this test?

The test is :



Assessment of Switching Basics Skills

Objectives

In this task we present you with a one-router, two-switch network. For that network, you must be able to accomplish the procedures listed below.
Configure VLANs on router R1.

Perform basic switch configuration.

Configure VTP.

Configure VLANs on switches.
Configure VLAN trunking.

You will be scored on each of these observables.

Preconfigs

The hostnames and all devices have been preconfigured.
Switch S1 and switch S2 have auto-negotiated a trunked link between the Fa0/2 interfaces on each switch.

Configuration Tasks

Complete each of the following tasks.

Configure VLANs on router R1

Configure and enable the Fa0/1 interface to trunk for VLAN 1, VLAN 10 and VLAN 20 with 802.1Q encapsulation to S1.
Use the following sub-interfaces:

Interface Fa0/1.1 = 172.16.1.1/24
Interface Fa0/1.10 = 172.16.10.1/24
Interface Fa0/1.20 = 172.16.20.1/24

Basic Switch Configuration

Configure and enable VLAN 1 on S1 with an IP address of 172.16.1.2/24.
Configure and enable VLAN 1 on S2 with an IP address of 172.16.1.3/24.
Configure both switches with the default gateway address of 172.16.1.1.

Configure VTP

Configure switch S1 and switch S2 as part of VTP domain Group1.
Configure switch S1 as the VTP server and switch S2 as the VTP client.

Configure VLANs and VLAN Access on Switches

Create VLAN 10 on switch S1 and name the VLAN Accounting.
Create VLAN 20 on switch S1 and name the VLAN Marketing.

Configure the following on switch S1:

Configure the interface Fa0/4 for access mode on VLAN 10.
Configure the interface Fa0/5 for access mode on VLAN 20.

Configure the following on switch S2:

Configure the interface Fa0/4 for access mode on VLAN 10.
Configure the interface Fa0/5 for access mode on VLAN 20.

Configure VLAN Trunking

Configure switch S1 for trunking between switch S1 and router R1 with 802.1Q encapsulation using port Fa0/1 on both devices.

NOTES:

Switch S1 and switch S2 have auto-negotiated a trunked link between the Fa0/2 interfaces on each switch.

InterVLAN routing can be verified by using the hosts attached to switch S1 and switch S2.

[dailyhustle]

anyone yet?